Home

Awesome

Nanoscope

An extremely accurate Android method tracing tool.

Overview

Nanoscope is a method tracing tool optimized for extreme accuracy. The tool's overhead has been measured at around ~20 nanoseconds per method (on a Nexus 6P). To achieve this performance, the interesting pieces of Nanoscope are implemented as a fork of AOSP. For this reason, you'll need to use the Nanoscope Emulator or a device running the Nanoscope OS in order to make use of this tool. The entrypoint for launching the Nanoscope emulator, provisioning a device with the custom OS, and starting/stopping tracing is the nanoscope command-line tool described below.

For more information on motivation and architecture, check out our blog post and the wiki.

Installation

Install the nanoscope command

$ brew tap uber/nanoscope
$ brew install nanoscope

Nanoscope Emulator / Devices

Nanoscope only works with the Nanoscope Emulator or with a device that's running the Nanoscope OS.

Launch Nanoscope Emulator

# Prerequisites
#   - $ANDROID_HOME environment variable is set
#   - macOS

$ nanoscope emulator

Flash ADB-connected phone with the Nanoscope OS

If you want to use Nanoscope with a real device, you can execute the following command to replace your stock Android OS with the Nanoscope OS.

IMPORTANT: This will only work with a Nexus 6P - do not attempt to flash any other device

IMPORTANT: This command installs a custom operating system onto the device. There is no way to undo this operation.

# Prerequisites
#   - Nexus 6p is the only supported device at this time
#   - OEM Unlocking is enabled (Settings -> Developer Options -> OEM unlocking)
#   - Device is connected via ADB

$ nanoscope flash

Usage

Start tracing on ADB-connected device

$ nanoscope start
Tracing... (Press ENTER to stop)

Startup tracing

$ nanoscope start --package=com.example.app
Tracing... (Press ENTER to stop)

It's necessary to specify the application package if you want to start tracing before running the app.

Extensions

In addition to method tracing, Nanoscope can generate additional information about executing application (e.g. CPU utilization for a given thread, number of page faults, object allocation information). You can enable this additional functionality by using --ext parameter with nanoscope start command. It is also necessary to change the kernel setting of Nexus 6P as follows:

$ adb shell "echo -1 >/proc/sys/kernel/perf_event_paranoid"

Please note that extended functionality DOES NOT work on emulators (and is therefore not included in our emulator release). Additional information about this Nanoscope extension can be found here.

Upgrade

Client

$ brew update && brew upgrade nanoscope

OS

$ brew update && brew upgrade nanoscope
$ nanoscope flash

License

Copyright (C) 2017 Uber Technologies

Licensed under the Apache License, Version 2.0 (the "License");
you may not use this file except in compliance with the License.
You may obtain a copy of the License at

   http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software
distributed under the License is distributed on an "AS IS" BASIS,
WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
See the License for the specific language governing permissions and
limitations under the License.