Awesome

Gameboy Printer Sniffer

Sniff packet Communications Between Real Gameboy And Real Gameboy Printer. This repository contains test vectors in ./RealCapture/ to assist in emulating a real Gameboy printer.

Written by Brian Khuu, but happy to accept contributions.

Originally part of https://github.com/mofosyne/arduino-gameboy-printer-emulator

Purpose

This is a tool to help investigate Gameboy behavior by sitting between a real Gameboy and a real Gameboy printer.

This is a spinoff of the Arduino Gameboy Printer Emulator V2 redesign, where we were aiming for full support for all games now.

To do this, we needed the ground truth, thus we need to sniff the communication between a real Gameboy printer and a real Gameboy.

Telegram Gameboy Camera Chatroom

Got telegram instant messaging and have some questions or need any advice, or just want to share? Invite link below:

https://t.me/GameboyCamera

Structure

./RealCapture/ : Real test vectors contributions from the community
./gbp_sniffer/ : Ardunio sketch for capturing packets between a real Gameboy and Gameboy printer.

Usage of gbp_sniffer (arduino)

gbp_sniffer is an arduino sketch, tested on an ardunio nano. To construct...

Split a cable and locate the GND, Serial Ouput, Serial Input and Clock.

Solder these wires to the arduino using the pinout shown below.

Plug a Gameboy and a printer to both ends of the cable. I've added auto detection routine so you don't have to worry about which ends to plug it in.

Next download ./gbp_sniffer/gpb_sniffer.ino to your arduino nano. After that, open the serial console and set the baud rate to 115200 baud.

You can now send an image over to the real Gameboy and the serial console will show the desired dump.

This will give you an output similar to those found in ./RealCapture/.

To view the content, you can use the raw decoder found here

General Pinout

Gameboy Original/Color Link Cable Pinout
 ___________
|  6  4  2  |
 \_5__3__1_/   (at cable)

Arduino Pin	Gameboy Link Pin
unused	Pin 1 : 5.0V
D4	Pin 2 : Serial OUTPUT
D3	Pin 3 : Serial INPUT
unused	Pin 4 : Serial Data
D2	Pin 5 : Serial Clock (Interrupt)
GND	Pin 6 : GND (Attach to GND Pin)

Thanks

Raphaël BOICHOT : For supplying real capture data in ./RealCapture/ folder