Awesome

Description

This is a simple Chef report handler that reports status of a Chef run through Growl.

http://wiki.opscode.com/display/chef/Exception+and+Report+Handlers

Requirements

Platform: Mac OS X

Growl: Tested with version 1.3.2

Uses the ruby_gntp library.

Usage

There are two ways to use Chef Handlers.

Method 1

You can install the RubyGem ahead of time, and configure Chef to use them. To do so:

gem install chef-handler-growl

Then add to the configuration (/etc/chef/solo.rb for chef-solo or /etc/chef/client.rb for chef-client):

require "chef/handler/growl"
report_handlers << Chef::Handler::Growl.new
exception_handlers << Chef::Handler::Growl.new

Method 2

Use the chef_handler cookbook by Opscode. Create a recipe with the following:

# Install the `chef-handler-growl` RubyGem during the compile phase
chef_gem "chef-handler-growl"

# Then activate the handler with the `chef_handler` LWRP
chef_handler "Chef::Handler::Growl" do
  source "chef/handler/growl"
  action :enable
end

Roadmap

Things I would like to add:

rspec tests - both Chef::Handler and GNTP#notify have specs, so this was low priority.
GNTP over the network capability. For example, if I have three virtual machines running Chef on an interval, I'd like them to send notification to my Mac workstation I'm using.

These are created as issues. Pull requests welcome.

License and Author

Licensed under the Apache License, Version 2.0 (the "License"); you may not use this file except in compliance with the License. You may obtain a copy of the License at

http://www.apache.org/licenses/LICENSE-2.0

Unless required by applicable law or agreed to in writing, software distributed under the License is distributed on an "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. See the License for the specific language governing permissions and limitations under the License.