Home

Awesome

USBaspLoader

Modded USBaspLoader to support with out changes in the code different programmers and devices.

Note than the bootloaderconfig.h is currently configured for Punk75 keyboard

D- being port D3 and BOOT(jumper) being port D4. You may need to change those to match your wiring.

Wiring

Flashing

To flash the USBasp bootloader to the DEVICE use the following command:

note than DEVICE, PROGRAMMER and PORT could be different for you. The supported programmers and ports are: (default device is atmega32)

PROGRAMMER  | PORT
------------+--------------
avrisp      | /dev/ttyACM*
usbasp      | not required - default
usbtiny     | not required
pony-stk200 | not required

make flash DEVICE=atmega32 PROGRAMMER=avrisp PORT=/dev/ttyACM0

then configure the fuses on the device with:

make fuse DEVICE=atmega32 PROGRAMMER=avrisp PORT=/dev/ttyACM0

Using a pro micro as ISP flasher

A regular pro micro or similars can be used as ISP flasher to install the bootlader in the DEVICE, although some changes and preparations are required.

Prepare the pro micro

To use the pro micro as an ISP flasher first we need to flash the ISP flashing code to it. To do so flash as regular this file from the QMK repo to your pro micro.

Wiring the pro micro

For most of the part the wiring is the same as regular, but instead of connecting the pro micro's RESET port to our DEVICE reset we'll connect the B10 port. These is the connection table:

Pro Micro 10 (B6)  <-> Keyboard RESET
Pro Micro 15 (B1)  <-> Keyboard B1 (SCLK)
Pro Micro 16 (B2)  <-> Keyboard B2 (MOSI)
Pro Micro 14 (B3)  <-> Keyboard B3 (MISO)
Pro Micro VCC      <-> Keyboard VCC
Pro Micro GND      <-> Keyboard GND

Now that we have prepared our pro micro and our DEVICE we can proceed to flash the bootloader.

Troubleshooting with the pro micro