Awesome
Card/IO firmware
This repository contains the firmware source code for the Card/IO open source ECG device, built with an ESP32-C6 or ESP32-S3 MCU.
This firmware is in its early stages of development.
Setup
Tools you need to build the firmware:
- Espressif's Xtensa-enabled rust compiler - espup
Make sure to run
. ~/export-esp.sh
before trying to work with the firmware cargo install cargo-espflash
cargo install cargo-watch
Enable External / USB JTAG selector solder bridge
pip install esptool
python -m espefuse burn_efuse --port COM4 STRAP_JTAG_SEL 1
Commands
cargo xtask -h
: Prints information about available commands. Most of the commands have short aliasses, listed below.cargo xbuild <hw>
: Build the firmware for a<hw>
version board.cargo xrun <hw>
: Build and run the firmware on a<hw>
version board.cargo monitor
: Connect to the Card/IO device and display serial output.<hw>
can be omitted, or one of:v4
,v6s3
,v6c6
. Defaults tov6c6
.cargo xcheck <hw>
: runscargo check
cargo xclippy <hw>
: runscargo clippy
cargo xdoc <hw> [--open]
: runscargo doc
and optionally opens the generated documentation.cargo xtest
: runscargo test
.cargo example <package> <example> [--watch]
: runs an example. Use--watch
to enable automatic reload when a file changes.- To run the config site on your PC, run
cargo example config-site simple --watch
and open127.0.0.1:8080
in a browser.