Awesome

dstemp

dstemp=github:bsiever/microbit-dstemp

This extension allows the micro:bit to use the Dallas Semiconductor DS18B20 temperature sensor.

Hardware

This module supports use of one or more DS18B20 temperature sensors. Each sensor must be connected to a separate pin and must include a 4.7k Ohm pull-up resistor between 3V and the signal.

Common wiring is:

• Micro:bit GND to GND (black wire) of the sensor
• Micro:bit 3V to Vdd (red wire) of the sensor
• Micro:bit I/O pin, like P0, to the data in/out (white wire) of the sensor

Getting the Temperature

dstemp.celsius(pin: DigitalPin) : number 

Get the current temperature in Celsius. Returns -Infinity on error.

Errors

dstemp.sensorError(errCallback: (errorMessage: string, errorCode: number, port: number) => void) { 

Report on any errors

• ||errorMessage|| will be a string describing the error
• ||errorCode|| will be a numeric code
• ||port|| will indicate which specific port encountered the error (if multiple sensors are connected)

Recommended usage

It's best to capture the temperature in a variable and only use it if the value isn't -Infinity. Since -300 C is below absolute zero, ensuring the temperature is over -300 is sufficient. For example:

temp = dstemp.celsius(DigitalPin.P0)
if (temp > -300) {
    basic.showString("" + (temp))
}