Awesome

RflyExpCode

This is the instructional package for 'Multicopter Design and Control Practice'. Please see https://rflysim.com for detailed information. You should download and install the RflySim Basic package to use the PPTs and codes, the download link is https://rflysim.com/download

Introduction

The model in "e0" is mainly used for the introduction of the experimental platform, corresponding to the relevant content in Chapters 3 and 4 of the book. The last 8 chapters of the book correspond to 8 experiments, of which Propulsion System Design Experiment has no relevant instructional package. Experiments 2 to 8 correspond to the contents of Chapters 6 to 12, and the corresponding files are e2 to e8. There are three sub-files in each folder, which correspond to the basic experiment, analysis experiment and design experiment in each experiment. Analysis experiment of chapter 2 has no source file package--"e2/e2.2",becasuse it mainly focus on theoretical calculation and analysis.

Details

The comparison between the instructional package and each experiment is as follows: e2:Dynamic Modeling Experiment; e3:Sensor Calibration Experiment; e4:State Estimation and Filter Design Experiment; e5:Attitude Controller Design Experiment; e6:Set-point Controller Design Experiment; e7:Semi-autonomous Control Model Design Experiment; e8:Failsafe Logic Design Experiment.

Notice

We don't provid design experiment package for students, and the code begining with "%@ " should be compeleted to make it right to run.If you can be certified as a teacher, we will give you all the packages.